Vetus M2.06 Wartungshandbuch PDF herunterladen (Seite 36)

Checking / adjusting valve clear-

ance

Checking the valve clearance must be

done with a cold engine, that is an engine

which did not run for at least 6 hours.

Remove rocker cover

Remove the 2 nuts of the rocker cover.

Complete the following steps:

Locating TDC

Locate the Top Dead Center (TDC), at the

end of the compression stroke, for cylin-

der 1 by barring the engine slowly until the

TDC marks of the engine block and the

crank pulley match.

Checking valve clearance

Every 500 operating hours.

Maintenance

VD00149

Mark on gear-

case

TDC mark

Injection timing

mark

VD01040

10 27

2 Cil.: 17°

3 C

il.: 19°

Note: There are two TDC’s e.g. compres-

sion and suction. At the TDC at the end

of the compression stroke the rocker arm

does not move when the crank pulley is

rotated a little.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 75 76

Keine Kommentare

Vetus M2.06 Wartungshandbuch Seite 36